Kabin tipi demonte mobilyalarda kavelalı minifiks köşe birleştirmelerde eğilme momenti üzerine minifiksler ve parça kenarları arasındaki uzaklıklarının etkisi
Citation
Malkoçoğlu, A , Çetin Yerlikaya, N . (2013). The Effect of Distances Between the Minifixes and Edges of Member on the Bending Moment at Dowel Minifix Corner Joints in the Cabinet-Type Ready-to-Assemble Furniture. Artvin Çoruh Üniversitesi Orman Fakültesi Dergisi, 15 (1), 9-19. DOI: 10.17474/acuofd.81475Abstract
Bu çalışmada kabin tipi demonte mobilyalarda L-tipi kavelalı minifiks köşe birleştirmelerin eğilme momentleri üzerine minifiksler ile parça kenarları arasındaki uzaklıkların (ön ve arka stopların) etkisi incelenmiştir. Bu amaçla; deney örnekleri için melamin kaplı lif levha (MKMDF) ve melamin kaplı yonga levha (MKYL) malzemeleri ile kavela ve minifiks birleştirme elemanları kullanılmıştır. Ön ve arka stoplar 60/36, 60/60 ve 48/48 mm olarak belirlenmiştir. Hazırlanan örnekler çekme ve basınç deneylerine tabi tutulmuştur. Deney sonuçlarına göre; stoplara ait eğilme moment değerleri 60/60’mm de en yüksek, 48/48 mm’de orta ve 60/36 mm’de ise en düşük çıkmıştır. Eğilme moment değerleri MKMDF malzemelerde YKYL’lardan, çekmede ise basınçtan daha yüksek çıkmıştır. Sonuç olarak; 228 mm derinlikteki mobilyada ön ve arka stop değerleri eşit ve 60 mm olarak önerilebilir In this study, the effect of distances between the minifixes and edges of member (front and rear stops) has been examinated on the bending moment of L-type dowel minifix corner joints in the cabinet-type ready-to-assemble furniture. For this purpose, dowel and minifix fasteners and melamine-coated fiberboard (MCF) and melamine-coated particle board (MCP) materials are used for test specimens. Front and rear stops were determined as 60/36, 60/60 and 48/48 mm. Test specimens which prepared were subjected to tension and compression tests. According to the results, the bending moment values of the stops have been obtained the maximum in 60/60 group, the minimum in 60/36 group, and the medium in 48/48 group. The bending moment values obtained that the fiberboard were obtained higher than particleboard, and the tension was obtained higher than compression. As a result, the front and rear stop values are recommended as equal and 60 mm for 228 mm deep furniture.