Pestisit üretiminde atıksuların koagülasyon/flokülasyon prosesi ile geri kazanımının değerlendirilmesi
Citation
Kati̇p, A . (2019). Pestisit Üretiminde Atıksuların Koagülasyon/Flokülasyon Prosesi ile Geri Kazanımının Değerlendirilmesi . Doğal Afetler ve Çevre Dergisi , 5 (1) , 94-100 . DOI: 10.21324/dacd.433279Abstract
Pestisit endüstrisi atıksularının toksik etkilere ve biyolojik birikime neden olması ve bu atıksuların yüksek kimyasal oksijen ihtiyacı
(KOİ) ve askıda katı madde (AKM) konsantrasyonları çevresel açıdan önemli problemlere yol açmaktadır. Ayrıca, pestisit
endüstrisinde üretilen pestisitlerin türüne ve kullanım özelliklerine göre atıksuların karakterizasyonu değişebilmektedir. Bu çalışmada
yaygın ve ekonomik olarak kullanılan alum (Al2(SO4)3.18H2O), demir (II) sülfatın (FeSO4.7H2O) ve demir (III) klorür (FeCl3.6H2O)
koagülantları ve anyonik polielektrolit (magnaflok) ile koagulasyon flokulasyon prosesi ile fizikokimyasal arıtabilirlik çalışması
yapılarak atıksuyun üretimde yeniden kullanımı değerlendirilmiştir. AKM ve KOİ giderilmesinde koagülasyon – flokülasyon prosesinin
giderim sağladığı ancak alıcı ortama deşarj için çok yeterli olmadığı görülmüştür. Demir (III) klorür, alum ve demir (II) sülfat için
optimum pH değerleri sırasıyla 7,21, 8,12 ve 7,18 ve optimum koagülant dozajları demir (III) klorür ve demir (II) sülfat için 250 mg/L,
alum için ise 300 mg/L olarak bulunmuştur. KOİ giderim verimleri demir (III) klorür, alum ve demir (II) sülfat için % 43, % 47 ve %
42, AKM giderim verimleri ise, demir (III) klorür için % 44, alum için % 47 ve demir (II) sülfat için % 39 bulunmuştur. Optimum
polielektrolit dozları alum ve demir (II) sülfat için 0,2 mg/L, demir (III) klorür için ise, 0,3 mg/L olarak belirlenmiştir. Sonuç olarak
bu koagulasyon-flokulasyon prosesi sonucunda elde edilen suyun geri kazanılarak üretimde kullanılabileceği belirlenmiştir. Pesticide industry wastewater causes toxic effects and bioaccumulation and high chemical oxygen demand (COD) and suspended
solids (SS) concentrations of these wastewaters cause environmental problems. Furthermore, the wastewater caused from pesticide
industry indicates great alteration in the wastewater characteristics subjected to the kind of agrochemicals produced and on the use
of materials manipulated. In this study wide found and economical coagulants; ferrous (III) chloride, alum, ferrous (II) sulphate, and
also a polyelectrolyte magnafloc were used for a physicochemical treatability study and reusing of the wastewater was evaluated. SS
and COD removal was ensured with coagulation and flocculation process, however, it was seen that this process was not sufficient for
discharging to receiving water environment. The optimum pH values for iron (III) chloride, alum and iron (II) sulphate were found to
be 7.21, 8.12 and 7.18, respectively and optimum coagulant dosages were 250 mg/L for iron (III) chloride and iron (II) sulfate, and
300 mg/L for alum. The COD removal efficiencies were 43%, 47% and 42% for iron (III) chloride, alum and iron (II) sulphate
respectively and also SS removal efficiencies were 44% for iron (III) chloride, 47% for alum, and iron (II) sulphate for 39%. Optimum
polyelectrolyte doses were determined to be 0.2 mg/L for alum and iron (II) sulfate and 0.3 mg/L for iron (III) chloride. Consequently,
it was ascertained that the wastewater originated from pesticide industry could be reused in production after the coagulation/
flocculation process.