Design and implementation of a 3D printed RF power transceiver clamp to measure the water level in PVC water pipes
Yükleniyor...
Dosyalar
Tarih
2021
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
John Wiley and Sons Inc
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
There is very few ways to detect the amount of water inside polyvinyl chloride (PVC) pipes without physical intervention. In this study, using additive manufacturing technology, it has been tried to determine the filling rate of water in PVC water pipes with a 3D printed clamp. The fact that the dielectric of distilled water is approximately 80 times that of air has been decisive in the transmission of power from the inner medium of the PVC pipe. In this way, when the amount of water increases in the PVC pipe, the RF power transmission will be decrease depending on level of water inner side of the pipe. The clamp was designed in the f0 = 2.45 GHz ISM band. LC impedance matching was applied to the two ports of the clamp. Thus, higher transmission coefficient was obtained. Used as a near field probe, the clamp was designed to be used horizontally anywhere on the pipe, pluggable. Input power from first port of the clamp is sent to the spectrum analyzer through its second port. The measurement and simulation results show that the transmission coefficient between the ports varies between ?9 dB and ?15 dB according to the selected fill percentages of the pipe.
Açıklama
Anahtar Kelimeler
3D printed clamp, PF probe, PVC pipe, Water fill rate
Kaynak
International Journal of RF and Microwave Computer-Aided Engineering
WoS Q Değeri
Q3
Scopus Q Değeri
Q2
Cilt
Article in pres
Sayı
Künye
Kasar, Ö., Geçin, M., & Gözel, M. A. Design and implementation of a 3D printed RF power transceiver clamp to measure the water level in PVC water pipes. International Journal of RF and Microwave Computer‐Aided Engineering, e22644.
